Datasheet
Positive
Voltmeter
PRINT
HELP
ALPHA
SHIFT
ENTER
RUN
D
G
E
R
F
I
A
J
B
K
C
L
7
M
8
N
9
O
D
G
D
G
D
G
D
G T
3
U
0
V
.
W
X
Y
Z
TAB
% UTILIZATION
HUB/MAU NIC
2
BNC
4Mb/s
+ -
Oscilloscope
Power
Supply
Negative
TPS2482/3EVM
J1
S1
J2
J8
D5
J4
J3
PC with GUI
Positive
Load
Negative
SM-USB-DIG
Current
probe
Test Setup
www.ti.com
4 Test Setup
4.1 5.1 TPS2482 and TPS2483 EVM GUI Installation
• Download the TPS2482 and TPS2483 INSTALLER.ZIP (SLVC454) file from the product page for the
devices on www.ti.com.
• Place the TPS2482 and TPS2483 INSTALLER.ZIP file in a known location on the PC. Unzip the
TPS2482-3 INSTALLER.ZIP file.
• Double click the unzipped setup.exe file which is located in the TPS2482 and TPS2483
Installer\Volume subdirectory. Proceed through the installation by accepting the prompts.
• Once the GUI completes the installation, the user is prompted to restart the computer.
Figure 2 shows a typical test setup for TPS2482 and TPS2483EVM.
4.2 EVM Hook up
Figure 2 shows a typical test setup for TPS2482 and TPS2483 EVM. Input voltage can be applied as
described in Table 2.
Figure 2. Typical TPS2482 and TPS2483 EVM Test Setup
• Connect the PC to the UUT J8 using the SM-USB-DIG and Type A Male to Type A Female USB v2.0
extension cable. Orient the SM-USB-DIG so that the TI bug is oriented as shown in Figure 2.
• Turn on the input power supply and enable the TPS2482 and TPS2483 EVM using S1. Apply a known
load to the circuit.
6
TPS2482 and TPS2483 Evaluation Module SLVU795–November 2012
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated