Datasheet

T FLT
10 μA
C = t
1.35 V
´
TPS24700
TPS24701
www.ti.com
SLVSAL3B MARCH 2011 REVISED MAY 2011
A fast-trip shutdown occurs when V
(VCCVSENSE)
exceeds 60 mV.
TIMER: A capacitor C
T
connected from the TIMER pin to GND determines the overload fault timing. TIMER
sources 10 μA when an overload is present, and discharges C
T
at 10 μA otherwise. M1 is turned off when V
TIMER
reaches 1.35 V. In an application implementing auto-retry after a fault, this capacitor also determines the period
before the external MOSFET is re-enabled. A minimum timing capacitance of 1 nF is recommended to ensure
proper operation of the fault timer. The value of C
T
can be calculated from the desired fault time t
FLT
, using
Equation 2.
(2)
The latch mode (TPS24700) or the retry mode (TPS24701) occurs if the load current exceeds the current limit
threshold or the fast-trip shutdown threshold. While in latch mode, the TIMER pin continues to charge and
discharge the attached capacitor periodically. In retry mode, the external MOSFET is disabled for sixteen cycles
of TIMER charging and discharging. The TIMER pin is pulled to GND by a 2-mA current source at the end of the
16
th
cycle of charging and discharging. The external MOSFET is then re-enabled. The TIMER pin capacitor, C
T
,
can also be discharged to GND during latch mode or retry mode by a 2-mA current source whenever any of the
following occurs:
V
EN
is below its falling threshold.
V
VCC
drops below the UVLO threshold.
VCC: This pin performs three functions. First, it provides biasing power to the integrated circuit. Second, it serves
as an input to the power-on reset (POR) and undervoltage lockout (UVLO) functions. The VCC trace from the
integrated circuit should connect directly to the positive terminal of R
SENSE
to minimize the voltage sensing error.
Bypass capacitor C
1
, shown in the typical application diagram on the front page, should be connected to the
positive terminal of R
SENSE
. A capacitance of at least 10 nF is recommended.
Copyright © 2011, Texas Instruments Incorporated Submit Documentation Feedback 7
Product Folder Link(s): TPS24700 TPS24701