Datasheet

( )
( )
AD _ IN max
IMON
LOAD max
63k V
R
I
W ´
=
OUT IN OUT
V V 0.04 I= - ´
TPS2420
SLUS903E –JANUARY 2009–REVISED MAY 2013 www.ti.com
VIN: Input voltage to the TPS2420. The recommended operating voltage range is 3 V to 18 V. All VIN pins
should be connected together and to the power source.
VOUT: Output connection for the TPS2420. When switched on the output voltage will be approximately:
(5)
All V
OUT
pins should be connected together and to the load.
LTCH: When pulled low the 2420 will attempt to restart after a fault. If left floating or pulled high the TPS2420 will
latch off after a fault. This pin is internally clamped at 3 V and is pulled to the internal 3-V supply by diode in
series with a 100-kΩ resistor.
PG: Active low, Open Drain output, Power Good indicates that there is no fault condition and the output voltage
is within 0.5 V of the input voltage. PG becomes operational before UV, whenever V
IN
is greater than 1 V.
IMON: This is a scaled analog output of I
VIN
. Select R
IMON
based on the maximum allowed A/D input voltage
(V
AD_FS
) and the desired full-scale current in VIN (I
VIN_FS
) per the following equation
(6)
This pin is clamped at 2.5 V to protect A/D converters. It is reccomended that I
MON
be ignored until after PG
asserts because the I
MON
output is accurate only after V
OUT
> 3 V.
8 Submit Documentation Feedback Copyright © 2009–2013, Texas Instruments Incorporated
Product Folder Links: TPS2420