Datasheet
ABSOLUTE MAXIMUM RATINGS
(1)
DISSIPATION RATINGS
TPS2410
TPS2411
SLVS727C – NOVEMBER 2006 – REVISED JUNE 2009 ..................................................................................................................................................
www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
ORDERING INFORMATION
(1)
DEVICE TEMPERATURE PACKAGE
(2)
ORDERING CODE MARKING
TPS2410 TPS2410PW TPS2410
– 40 ° C to 85 ° C PW (TSSOP-14)
TPS2411 TPS2411PW TPS2411
(1) Add an R suffix to the device type for tape and reel.
(2) For the most current package and ordering information, see the Package Option Addendum at the end
of this document, or see the TI website at www.ti.com .
over operating free-air temperature range, voltage are referenced to GND (unless otherwise noted)
VALUE UNIT
A, C, FLTR, V
DD
, STAT voltage – 0.3 to 18 V
A above C voltage
(2)
7.5 V
C above A voltage 18 V
GATE
(3)
, BYP voltage – 0.3 to 30 V
BYP
(3)
to A voltage – 0.3 to 13 V
GATE above BYP voltage 0.3 V
FLTR
(3)
to C voltage – 0.3 to 0.3 V
OV, UV voltage – 0.3 to 5.5 V
RSET voltage
(3)
– 0.3 to 7 V
FLTB, PG voltage – 0.3 to 18 V
STAT, PG, FLTB sink current 40 mA
GATE short to A or C or GND Indefinite
Human body model 2 kV
ESD
Charged device model 500 V
T
J
Maximum junction temperature Internally limited ° C
T
stg
Storage temperature – 65 to 150 ° C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) See the section " Bidirectional Blocking and Protection of C. "
(3) Voltage should not be applied to these pins.
POWER RATING
PACKAGE θ
JA
– Low k ° C/W θ
JA
– High k ° C/W
High k T
A
= 85 ° C (mW)
PW (TSSOP) 173 99 404
2 Submit Documentation Feedback Copyright © 2006 – 2009, Texas Instruments Incorporated
Product Folder Link(s): TPS2410 TPS2411