Datasheet
Table Of Contents

TPS2378
www.ti.com
SLVSB99B –MARCH 2012–REVISED NOVEMBER 2013
The type 2 hardware classification protocol of IEEE 802.3at specifies that a type 2 PSE drops its output voltage
into the detection range during the classification sequence. The PD is required to have an incorrect detection
signature in this condition, which is referred to as a mark event (see Figure 19). After the first mark event, the
TPS2378 will present a signature less than 12 kΩ until it has experienced a V
(VDD-VSS)
voltage below the mark
reset threshold (V
MSR
). This is explained more fully under Hardware Classification.
Hardware Classification
Hardware classification allows a PSE to determine a PD’s power requirements before powering, and helps with
power management once power is applied. Type 2 hardware classification permits high power PSEs and PDs to
determine whether the connected device can support high-power operation. A type 2 PD presents class 4 in
hardware to indicate that it is a high-power device. A type 1 PSE will treat a class 4 device like a class 0 device,
allotting 13 W if it chooses to power the PD. A PD that receives a 2-event class understands that it is powered
from a high-power PSE and it may draw up to 25.5 W immediately after the 80 ms startup period completes. A
type 2 PD that does not receive a 2-event hardware classification may choose to not start, or must start in a 13
W condition and request more power through the DLL after startup. The standard requires a type 2 PD to
indicate that it is underpowered if this occurs. Startup of a high-power PD under 13 W implicitly requires some
form of powering down sections of the application circuits.
The maximum power entries in Table 1 determine the class the PD must advertise. The PSE may disconnect a
PD if it draws more than its stated Class power, which may be the hardware class or a lower DLL-derived power
level. The standard permits the PD to draw limited current peaks that increase the instantaneous power above
the Table 1 limit, however the average power requirement always applies.
The TPS2378 implements two-event classification. Selecting an R
CLS
of 63.4 Ω provides a valid type 2 signature.
TPS2378 may be used as a compatible type 1 device simply by programming class 0–3 per Table 1. DLL
communication is implemented by the Ethernet communication system in the PD and is not implemented by the
TPS2378.
The TPS2378 disables classification above V
CU_ON
to avoid excessive power dissipation. CLS voltage is turned
off during PD thermal limiting or when APD or DEN is active. The CLS output is inherently current limited, but
should not be shorted to V
SS
for long periods of time.
Figure 20 shows how classification works for the TPS2378. Transition from state-to-state occurs when
comparator thresholds are crossed (see Figure 17 and Figure 18). These comparators have hysteresis, which
adds inherent memory to the machine. Operation begins at idle (unpowered by PSE) and proceeds with
increasing voltage from left to right. A 2-event classification follows the (heavy lined) path towards the bottom,
ending up with a latched type 2 decode along the lower branch that is highlighted. This state results in a low T2P
during normal operation. Once the valid path to type 2 PSE detection is broken, the input voltage must transition
below the mark reset threshold to start anew.
Copyright © 2012–2013, Texas Instruments Incorporated Submit Documentation Feedback 13
Product Folder Links: TPS2378