Datasheet

TPS2359
Backplane
SUM3xSUM12x
R
SUM3x
R
SUM12x
Power Source 1
TPS2359
SUM3xSUM12x
Power Source 2
TPS2359
SUM3xSUM12x
Power Source 1
TPS2359
SUM3xSUM12x
Power Source 2
MicroTCA
TM
Redundancy
Multiswap Redundancy
Backplane
R
SUM12x
R
SUM3x
mC
R
SUM3x
R
SUM12x
mC
TPS2359
SLUS792H –FEBRUARY 2008–REVISED MAY 2013 www.ti.com
Multiswap Operation in Redundant Systems
TheTPS2359 features an additional mode of operation called Multiswap redundancy. This technique does not
require a microcontroller, making it simpler and faster than the redundancy schemes described in the
MicroTCA™ standard. Multiswap is especially attractive for AdvancedMC™ applications requiring redundancy,
but need not comply with the MicroTCA™ power module standard.
In order to implement multiswap redundancy, connect the SUM pins of the redundant channels together and tie a
single R
SUM
resistor from this node to ground. The current limit thresholds now apply to the sum of the currents
delivered by the redundant supplies. When implementing multiswap redundancy on 12-V channels, all of the
channels must use the same values of resistors for R
SENSE
and R
SET
.
Figure 27 compares the redundancy technique advocated by the MicroTCA™ specification with multiswap
redundancy. MicroTCA™ redundancy independently limits the current delivered by each power source. The
current drawn by the load cannot exceed the sum of the current limits of the individual power sources. Multiswap
redundancy limits the current drawn by the load to a fixed value regardless of the number of operational power
sources. Removing or inserting power sources within a multiswap system does not affect the current limit seen
by the load.
Figure 27. MicroTCA Redundancy vs. Multiswap Redundancy
36 Submit Documentation Feedback Copyright © 2008–2013, Texas Instruments Incorporated
Product Folder Links: TPS2359