Datasheet

5 Test Set-Up
5.1 Equipment Requirements
www.ti.com Test Set-Up
The following test and interface equipment (not supplied) is required to verify EVM module operation, and
begin using the EVM.
• Power supply, 3.3 VDC, 500 mA minimum
• Power supply, 15 VDC, 10 A minimum
• Digital multimeters
• Oscilloscope, 4 channel, with current probe
• Personal computer, running Windows OS (95/98/2000/NT/XP), with USB port
Connect the TPS2359EVM and test equipment as shown in Figure 3 for functional check-out of the board
and a good starting point for user evaluation of device operation. Screen print labeling on the board
employs a naming convention in keeping with the nomenclature of the target ATCA™ and MicroTCA™
applications. Input 3.3-V supplies are connected to the 3V3INx jacks, and 12-V supplies are connected to
the 12VINx jacks. A cross-reference of power rail labeling to standards naming is shown in Table 4 .
Table 4. TPS2359EVM Output Net and Jack Naming
REF DES CONNECTOR LABEL DESCRIPTION
J8 SLOT A MP AdvancedMC™ Slot A Management Power
J7 SLOT A PWR AdvancedMC™ Slot A Payload Power
J9 GND Common load return node for Slot A
J11 SLOT B MP AdvancedMC™ Slot B Management Power
J10 SLOT B PWR AdvancedMC™ Slot B Payload Power
J12 GND Common load return node for Slot B
SLUU318 – August 2008 7
TPS2359 Dual-Slot ATCA™ AdvancedMC™ Controller with I
2
C Evaluation Module
Submit Documentation Feedback