Datasheet
SLVS317 − MAY 2001
4
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
absolute maximum ratings over operating free-air temperature (unless otherwise noted)
†
Input voltage range for card power: V
I(3.3V
) −0.3 V to 5.5 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
V
I(5V)
−0.3 V to 5.5 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
V
I(12V)
‡
−0.3 V to 14 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Logic input/output voltage −0.3 V to 6 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output voltage: V
O(xVCC)
−0.3 V to 6 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
V
O(xVPP)
−0.3 V to 14 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous total power dissipation See Dissipation Rating Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output current: I
O(xVCC)
Internally Limited. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I
O(xVPP)
Internally Limited. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating virtual junction temperature range, T
J
−40°C to 100°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
STG
−55°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature 1.6 mm (1/16 inch) from case for 10 seconds) 260°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OC
sink current 10 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
†
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
‡
Not applicable for TPS2223
DISSIPATION RATING TABLE
PACKAGE
§
T
A
≤ 25°C
POWER RATING
DERATING FACTOR
ABOVE T
A
= 25°C
T
A
= 70°C
POWER RATING
T
A
= 85°C
POWER RATING
DB
24 890 mW 8.9 mW/°C 489 mW 356 mW
DB
30 1095 mW 10.95 mW/°C 602 mW 438 mW
PWP 24 3322 mW 33.22 mW/°C 1827 mW 1329 mW
§
These devices are mounted on an JEDEC low-k board (2-oz. traces on surface).
recommended operating conditions
MIN MAX UNIT
Input voltage, V
I(3.3V)
is required for all circuit operations. 5V and
V
I(3.3V)
¶
3 3.6
Input voltage, V
I(3.3V)
is required for all circuit operations. 5V and
12V are only required for their respective functions.
V
I(5V)
3 5.5
V
12V are only required for their respective functions.
V
I(12V)
‡
7 13.5
V
Output current, I
O
I
O(xVCC)
at T
J
= 100°C 1 A
Output current, I
O
I
O(xVPP)
at T
J
= 100°C 100 mA
Clock frequency, f
(clock)
2.5 MHz
Data 200
Pulse duration, t
w
Latch 250
ns
Pulse duration, t
w
Clock 100
ns
Reset 100
Data-to-clock hold time (see Figure 2) 100 ns
Data-to-clock setup time, t
su
(see Figure 2) 100 ns
Latch delay time, t
d(latch)
(see Figure 2) 100 ns
Clock delay time, t
d(clock)
(see Figure 2) 250 ns
Operating virtual junction temperature, T
J
(maximum to be calculated at worst cast P
D
at 85°C ambient) −40 100 °C
‡
Not applicable for TPS2223
¶
It is understood that for V
I(3.3V)
< 3 V, voltages within the absolute maximum ratings applied to pin 5V or pin 12V will not damage the IC.