Datasheet

V
IN
- +
EVM Under Test
J2
J3
J1
- +
TP4
TP7
LOAD
Oscilloscope
OUT
IN
- +
EVM Setup www.ti.com
4 EVM Setup
4.1 Recommended Test Equipment
The following test equipment is recommended:
• Two-channel storage oscilloscope
• Current probe
• Voltage probe
• 5 V at 5-A power supply
• Volt-ohm meter
• A passive or active load
4.2 Measuring Current Limit
The user is advised to read the applicable data sheet before using the EVM.
Figure 9 shows the EVM test setup for measuring current limit. The power distribution switch is enabled
into a short circuit for this measurement. Figure 10 shows the current waveform for TPS2069CDGNEVM-
635.
Figure 9. EVM Setup For Measuring Current Limit
10
Single-Channel, Power-Distribution Switch Evaluation Module SLVU466B–June 2011–Revised July 2012
Submit Documentation Feedback
Copyright © 2011–2012, Texas Instruments Incorporated