Datasheet

EVM Configuration

www.ti.com

4 EVM Configuration

The TPD12S016 EVM has three separate sections,

the TOP, MIDDLE, and BOTTOM sections. Each

section includes a TPD12S016, input/output (IO) ports,

and jumper switches for enabling or disabling the

TPD12S016’s Level Shifter (LS), Hot Plug Detect and

5VOUT. VCC can be powered by either an HDMI input

or a 5V SUPPLY banana clip.

OUTPUT is side B; INPUT is side A. TOP, MIDDLE,

and BOTTOM sections are all supplied with power

using VBAT, VCCA, and GND.

1. The TOP section has Type-A HDMI male

connectors for IO.

2. The MIDDLE section has Type-C HDMI male

connectors for IO.

3. The BOTTOM section has a Type-A male

connector as input for the four differential pair

signals only. For probe testing of the high-speed

differential signals, test points are provided on the

board. Configurable output loads using R1-R8 &

C1-C4 are provided. This configuration provides a

means for developing eye diagrams under no load

or loaded conditions

Jumper Switch Configurations

LS (LS_OE) disabled enabled

CT_CP_HPD disabled enabled

Using the +5Vout of TPD12S016 Bypass +5VOUT of TPD12S016

Selects source of output's +5

Power Signal (Pin 18)

TPD12S016 Evaluation Module SLLU154– September 2011

Submit Documentation Feedback