Datasheet

2-1

Quick Start

The steps in this chapter can be followed to quickly prepare the TPA711 MSOP

audio amplifier EVM for use. Using the TPA711 MSOP EVM with the TI

plug-n-play audio amplifier evaluation platform is a quick and easy way to

connect power, signal and control inputs, and signal outputs to the EVM, using

standard connectors. However, the audio amplifier evaluation module can be

used stand-alone by making connections directly to the module pins, and it can

be wired directly into existing circuits or equipment.

The platform switch and jumper settings shown in Table 2–1 are typical for the

TPA711 MSOP EVM. They will cause the TPA711 IC to mute switch to single-

ended output mode when a plug is inserted into platform headphone jack J10.

Table 2–1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the TPA711

MSOP EVM

EVM JP6 JP7 JP8 S2 S3

TPA711 Mode X Hi Note 2 X

Notes: 1) X = Don’t care

2) Set S2 to ON when signal conditioning board is installed in U1; set S2

to OFF when no signal conditioning board is installed.

Topic Page

2.1 Precautions 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.2 Quick Start List for Platform 2–3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.3 Quick Start List for Stand-Alone 2–4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Chapter 2