Datasheet
www.ti.com
ABSOLUTE MAXIMUM RATINGS
(1)
DISSIPATION RATINGS TABLE
RECOMMENDED OPERATING CONDITIONS
TPA6130A2
SLOS488B – NOVEMBER 2006 – REVISED FEBRUARY 2008
over operating free-air temperature range, T
A
= 25 ° C (unless otherwise noted)
VALUE / UNIT
Supply voltage, V
DD
– 0.3 V to 6.0 V
RIGHTINx, LEFTINx – 2.7 V to 3.6 V
V
I
Input voltage
SD, SCL, SDA – 0.3 V to 7 V
Output continuous total power dissipation See Dissipation Rating Table
T
A
Operating free-air temperature range – 40 ° C to 85 ° C
T
J
Operating junction temperature range – 40 ° C to 125 ° C
T
stg
Storage temperature range – 65 ° C to 150 ° C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 260 ° C
HBM Output Pins 8 kV
ESD Protection
HBM All Other Pins 3.5 kV
No External Protection 8 kV
IEC Contact ESD Protection
(2)
V14MLA0603 Varistors Used for External Protection 15 kV
Minimum Load Impedance 12.8 Ω
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) Tested to IEC 61000-4-2 standards on a TPA6130A2 EVM.
T
A
≤ 25 ° C DERATING T
A
= 70 ° C T
A
= 85 ° C
PACKAGE
POWER RATING FACTOR
(1) (2)
POWER RATING POWER RATING
RTJ 4100 mW 41 mW/ ° C 2250 mW 1640 mW
YZH 970 mW 9.7 mW/ ° C 530 mW 390 mW
(1) Derating factor measured with JEDEC High K board: 1S2P - One signal layer and two plane layers.
(2) See JEDEC Standard 51-3 for Low-K board, JEDEC Standard 51-7 for High-K board, and JEDEC
Standard 51-12 for using package thermal information. Please see JEDEC document page for
downloadable copies: http://www.jedec.org/download/default.cfm .
AVAILABLE OPTIONS
T
A
PACKAGED DEVICES
(1)
PART NUMBER SYMBOL
20-pin, 4 mm × 4 mm QFN TPA6130A2RTJ
(2)
BSG
– 40 ° C to 85 ° C
16-ball, 1,98 mm × 1.98 mm
TPA6130A2YZH BRU
(+0,01mm, – 0,09 mm)
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
Web site at www.ti.com .
(2) The RTJ package is only available taped and reeled. To order, add the suffix “ R ” to the end of the part number for a reel of 3000, or add
the suffix “ T ” to the end of the part number for a reel of 250 (e.g., TPA6130A2RTJR).
MIN MAX UNIT
Supply voltage, V
DD
2.5 5.5 V
V
IH
High-level input voltage SCL, SDA, SD 1.3 V
SCL, SDA 0.6 V
V
IL
Low-level input voltage
SD 0.35 V
T
A
Operating free-air temperature – 40 85 ° C
4 Copyright © 2006 – 2008, Texas Instruments Incorporated
Product Folder Link(s): TPA6130A2