Datasheet

1.3 TPA2036D1 EVM Specifications
2 Operation
2.1 Precautions
www.ti.com Operation
Supply voltage range, V
DD
2.5 V to 5.5 V
Power supply current rating required 1 A
Continuous output power, P
O
: 4- Ω BTL, V
DD
= 5 V 2.5 W
Audio input voltage, V
I
0 V to V
DD
, max
Minimum load impedance, Z
L
4 Ω
Follow the steps in this chapter to prepare the TPA2036D1 audio amplifier EVM for use. Using the
TPA2036D1 EVM with the TI Plug-N-Play audio amplifier evaluation platform is a quick and easy way to
connect power, signal and control inputs, and signal outputs to the EVM, using standard connectors.
However, the audio amplifier evaluation module can be used stand-alone by making connections directly
to the module pins, and it can be wired directly into existing circuits or equipment.
The platform switch and jumper settings shown in Table 1 are typical for the TPA2036D1 EVM. They
cause the TPA2036D1 amplifier IC on the EVM to shut down when a plug is inserted into platform
headphone jack J10.
Table 1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the TPA2036D1 EVM
EVM JP6 JP7 JP8 S2 S3
TPA2036D1 Mute X
(1)
Lo See
(2)
X
(1)
X = Don't care
(2)
Set S2 to On when signal conditioning board is installed in U1; set S2 to Off when no signal conditioning board is installed.
CAUTION
Power Supply Input Polarity and Maximum Voltage
Always ensure that the polarity and voltage of the external power connected to
V
CC
power input connector J1, J2, and/or V
DD
power input connector J6 are
correct. Overvoltage or reverse-polarity power applied to these terminals can
open onboard soldered-in fuses and cause other damage to the platform,
installed evaluation modules, and/or the power source.
CAUTION
Inserting or Removing EVM Boards
Do not insert or remove EVM boards with power applied – damage to the EVM
board, the platform, or both may result.
SLOU238 – August 2008 TPA2036D1 Audio Power Amplifier Evaluation Module 3
Submit Documentation Feedback