Datasheet

Quick Start List for Platform
2-4
Operation
Inputs and outputs
8) Ensure that the audio signal source level is set to minimum.
9) Connect the audio source to left and right RCA phono jacks J3 and J5 or
stereo miniature phone jack J4.
10) The outputs are to be configured in the following manner:
a) Connect speakers to left and right RCA jacks J7 and J9 or to stripped
wire speaker connectors J8.
or
b) Insert the headphone into the onboard headphone jack (J3).
Evaluation Module Preparations
11) Use jumpers GAIN0 and GAIN1 to set the gain (see Figure 2–2 and
Table 2–4).
Figure 2–2. Module Preparation
11
Table 2–4. Typical TPA2000D4 EVM Jumper Settings
GAIN1 GAIN0 GAIN (dB)
ON ON 5
ON OFF 11
OFF ON 17
OFF OFF 23
Note: ON = Jumper installed, OFF = Open, X = Don’t care