Datasheet

www.ti.com
APPLICATION INFORMATION
ELIMINATING THE OUTPUT FILTER WITH THE TPA2000D1
EFFECT ON AUDIO
TRADITIONAL CLASS-D MODULATION SCHEME
O V
–5 V
+5 V
Current
OUTP
Differential Voltage
Across Load
OUTN
TPA2000D1 MODULATION SCHEME
TPA2000D1
SLOS328F – JUNE 2000 – REVISED MARCH 2004
This section explains why the user can eliminate the output filter with the TPA2000D1.
The class-D amplifier outputs a pulse-width modulated (PWM) square wave, which is the sum of the switching
waveform and the amplified input audio signal. The human ear acts as a band-pass filter such that only the
frequencies between approximately 20 Hz and 20 kHz are passed. The switching frequency components are
much greater than 20 kHz, so the only signal heard is the amplified input audio signal.
The traditional class-D modulation scheme, which is used in the TPA005Dxx family, has a differential output
where each output is 180 degrees out of phase and changes from ground to the supply voltage, V
DD
. Therefore,
the differential prefiltered output varies between positive and negative V
DD
, where filtered 50% duty cycle yields
0 V across the load. The traditional class-D modulation scheme with voltage and current waveforms is shown in
Figure 9 . Even at an average of 0 V across the load (50% duty cycle), the current to the load is high, causing
high loss, and a high supply current.
Figure 9. Traditional Class-D Modulation Scheme Output Voltage and Current Waveforms Into an
Inductive Load With No Input
The TPA2000D1 uses a modulation scheme that still has each output switching from 0 to the supply voltage.
However, OUTP and OUTN are now in phase with each other with no input. The duty cycle of OUTP is greater
than 50% and OUTN is less than 50% for positive voltages. The duty cycle of OUTP is less than 50% and OUTN
is greater than 50% for negative voltages. The voltage across the load sits at 0 V throughout most of the
switching period greatly reducing the switching current, which reduces any I
2
R losses in the load.
9