Datasheet

www.ti.com
ABSOLUTE MAXIMUM RATINGS
TPA2000D1
SLOS328F – JUNE 2000 – REVISED MARCH 2004
TERMINAL FUNCTIONS
TERMINAL
NO. I/O DESCRIPTION
NAME
GQC PW
A3 - A5,
B2 - B6
AGND 15 I Analog ground
C2 - C6
D2 - D4
BYPASS A6 16 I Connect capacitor to ground for BYPASS voltage filtering.
COSC B7 14 I Connect capacitor to ground to set oscillation frequency.
GAIN0 C1 4 I Bit 0 of gain control (TTL logic level)
GAIN1 D1 5 I Bit 1 of gain control (TTL logic level)
INN A1 2 I Negative differential input
INP A2 1 I Positive differential input
OUTN G7 10 O Negative BTL output
OUTP G1 7 O Positive BTL output
D5, D6
E2 - E6
PGND 8, 9 I High-current grounds
F2 - F6
G2 - G6
E1, E7,
PV
DD
6, 11 I High-current power supplies
F1, F7
ROSC C7 13 I Connect resistor to ground to set oscillation frequency.
Places the amplifier in shutdown mode if a TTL logic low is placed on this terminal, and
SHUTDOWN B1 3 I
normal operation if a TTL logic high is placed on this terminal.
V
DD
D7 12 I Analog power supply
over operating free-air temperature range (unless otherwise noted)
(1)
UNITS
Supply voltage V
DD,
PV
DD
-0.3 V to 5.5 V
Input voltage, V
I
-0.3 V to V
DD
+0.3 V
Continuous total power dissipation (See Dissipation Rating Table)
Operating free-air temperature range, T
A
-40°C to 85°C
Operating junction temperature range, T
J
-40°C to 150°C
Storage temperature range, T
stg
-65°C to 150°C
Lead temperature 1, 6 mm (1/16 inch) from case for 10 seconds 260°C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
DISSIPATION RATING TABLE
PACKAGE T
A
≤ 25°C DERATING FACTOR T
A
= 70°C T
A
= 85°C
PW 774 mW 6.19 mW/°C 495 mW 402 mW
GQC 2.61 W 20.9 mW/°C 1.67 W 1.36 W
3