Datasheet

Quick Start List for Stand-Alone

2-6

Operation

 Evaluation module preparations

6) Set the EVM jumpers as shown in Table 2–5.

Table 2–5. Typical TPA0213 EVM Jumper Settings

EVM J1 J2

TPA0213 ON ON

Note: ON = Shunt installed

OFF = Open

EVM jumpers J1 and J2 allow the MONO-IN input pin to be driven from either

the MIN test point or from a combination of the left and right channel inputs.

The four possible configurations are shown in Table 2–6.

Table 2–6. TPA0213 EVM MONO-IN Input Configurations

J1 J2 MONO-IN INPUT

OFF OFF MIN test point

OFF ON RIN only

ON OFF LIN only

ON ON Sum of LIN and RIN

Notes: 1) ON = Shunt installed, OFF = Open

2) If the MIN input is used as the mono input, potentiometer R2 may be used to adjust

the EVM gain.

7) Adjust EVM potentiometers R4 and R8 to approximately mid point.

 Power-up

8) Verify correct voltage and input polarity, and set the external power supply

ON.

The EVM should begin operation.

9) Adjust the signal source level or adjust potentiometers R4 and R8 on the

EVM as needed.