Datasheet

2-1
Operation
Operation
The quick start lists in this chapter contain steps that can be followed to quickly
prepare the TPA0213 mono audio amplifier EVM for use either with the TI
plug-n-play audio amplifier evaluation platform or for stand-alone operation.
Using the EVM with the TI evaluation platform is a quick and easy way to
connect power, signal and control inputs, and signal outputs to the EVM, using
standard connectors.
The platform switch and jumper settings shown in Table 2–1 are typical for the
TPA0213 EVM.
Table 2–1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the TPA0213
EVM JP6 JP7 JP8 S2 S3
P-N-P Platform Mode X Hi Note 2 X
Notes: 1) X = Don’t care
2) Set S2 to ON when signal conditioning board is installed in U1; set S2
to OFF when no signal conditioning board is installed.
Table 2–2. Typical TPA0213 EVM Jumper Settings
EVM J1 J2
TPA0213 ON ON
Note: ON = Shunt installed
OFF = Open
Topic Page
2.1 Precautions 2–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Quick Start List for Platform 2–3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Quick Start List for Stand-Alone 2–5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.4 Stand-Alone Connection Diagrams 2–7. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.5 Reference 2–9. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2