Serial RapidIO (SRIO) User's Guide

www.ti.com
2.3.13.3 Peripheral Initializations
SRIO Functional Description
SRIO_REGS->SERDES_CFG0_CNTL = 0x00000013;
SRIO_REGS->SERDES_CFG1_CNTL = 0x00000000;
SRIO_REGS->SERDES_CFG2_CNTL = 0x00000000;
SRIO_REGS->SERDES_CFG3_CNTL = 0x00000000;
SRIO_REGS->SERDES_CFGRX0_CNTL = 0x00081121 ; // enable rx, half rate
SRIO_REGS->SERDES_CFGRX1_CNTL = 0x00081121 ; // enable rx, half rate
SRIO_REGS->SERDES_CFGRX2_CNTL = 0x00081121 ; // enable rx, half rate
SRIO_REGS->SERDES_CFGRX3_CNTL = 0x00081121 ; // enable rx, half rate
SRIO_REGS->SERDES_CFGTX0_CNTL = 0x00010821 ; // enable tx, half rate
SRIO_REGS->SERDES_CFGTX1_CNTL = 0x00010821 ; // enable tx, half rate
SRIO_REGS->SERDES_CFGTX2_CNTL = 0x00010821 ; // enable tx, half rate
SRIO_REGS->SERDES_CFGTX3_CNTL = 0x00010821 ; // enable tx, half rate
Set Device ID Registers
rdata = SRIO_REGS->DEVICEID_REG1;
wdata = 0x00ABBEEF;
mask = 0x00FFFFFF;
mdata = (wdata & mask) | (rdata & ~mask);
SRIO_REGS->DEVICEID_REG1 = mdata ; // id-16b=BEEF, id-08b=AB
rdata = SRIO_REGS->DEVICEID_REG2;
wdata = 0x00ABBEEF;
mask = 0x00FFFFFF;
mdata = (wdata & mask) | (rdata & ~mask);
SRIO_REGS->DEVICEID_REG2 = mdata ; // id-16b=BEEF, id-08b=AB
rdata = SRIO_REGS->PER_SET_CNTL;
data = 0x00000000;
mask = 0x01000000;
mdata = (wdata & mask) | (rdata & ~mask);
SRIO_REGS->PER_SET_CNTL = mdata; // bootcmpl=0
SRIO_REGS->DEV_ID = 0xBEEF0030 ; // id=BEEF, ti=0x0030
SRIO_REGS->DEV_INFO = 0x00000000 ; // 0
SRIO_REGS->ASBLY_ID = 0x00000030 ; // ti=0x0030
SRIO_REGS->ASBLY_INFO = 0x00000000; // 0x0000, next ext=0x0100
SRIO_REGS->PE_FEAT = 0x20000019 ; // proc, bu ext, 16-bit ID, 34-bit addr
SRIO_REGS->SRC_OP = 0x0000FDF4; // all
SRIO_REGS->DEST_OP = 0x0000FC04; // all except atomic
SRIO_REGS->PE_LL_CTL = 0x00000001; // 34-bit addr
SRIO_REGS->LCL_CFG_HBAR = 0x00000000 ; // 0
SRIO_REGS->LCL_CFG_BAR = 0x00000000; // 0
SRIO_REGS->BASE_ID = 0x00ABBEEF; // 16b-id=BEEF, 08b-id=AB
SRIO_REGS->HOST_BASE_ID_LOCK = 0x0000BEEF; // id=BEEF, lock
SRIO_REGS->COMP_TAG = 0x00000000; // not touched
SRIO_REGS->SP_IP_DISCOVERY_TIMER = 0x90000000;// 0, short cycles for sim
SRIO_REGS->IP_PRESCAL = 0x00000021; // srv_clk prescalar=0x21 (333MHz)
SRIO_REGS->SP0_SILENCE_TIMER = 0x20000000;
SRIO_REGS->SP1_SILENCE_TIMER = 0x20000000;
SRIO_REGS->SP2_SILENCE_TIMER = 0x20000000;
SRIO_REGS->SP3_SILENCE_TIMER = 0x20000000;
rdata = SRIO_REGS->PER_SET_CNTL;
wdata = 0x01000000;
mask = 0x01000000;
mdata = (wdata & mask) | (rdata & ~mask);
SRIO_REGS->PER_SET_CNTL = mdata; // bootcmpl=1
RIO_REGS->SP_LT_CTL = 0xFFFFFF00; // long
78 Serial RapidIO (SRIO) SPRUE13A – September 2006
Submit Documentation Feedback