Serial RapidIO (SRIO) User's Guide

www.ti.com
SRIO Registers
Table 177. Port IP Mode CSR (SP_IP_MODE) Field Descriptions (continued)
Bit Field Value Description
3 RST_EN Reset Interrupt Enable. If enabled, the interrupt signal is High when the 4 reset control symbols
are received in a sequence
0 Reset interrupt disable
1 Reset interrupt enable
2 RST_CS Reset received status bit. It is set when Once set, the RST_CS bit remains set until software
writes a 1 to it. The rst_irq output signal is driven by this bit.
0 Four reset control symbols have not been received in a sequence.
1 Four reset control symbols have been received in a sequence.
1 PW_EN Port-Write-In Interrupt Enable. If enabled, the interrupt signal is High when the Port-Write-In
request is received
0 Port-Write-In interrupt disable
1 Port-Write-In interrupt enable
0 PW_IRQ Port-Write-In request interrupt. Once set, the PW_IRQ bit remains set until software writes a 1
to it. The pw_irq output signal is driven by this bit.
0 The Port-Write-In request has not been received.
1 The Port-Write-In request has been received. The payload is captured.
Serial RapidIO (SRIO)232 SPRUE13A – September 2006
Submit Documentation Feedback