Serial RapidIO (SRIO) User's Guide

www.ti.com
5.24 Error, Reset, and Special Event Interrupt Condition Status Register
SRIO Registers
(ERR_RST_EVNT_ICSR)
Each of the nonreserved bits in this register indicate the status of a particular interrupt condition in one or
more of the SRIO ports. ERR_RST_EVNT_ICSR is shown in Figure 85 and described in Table 75 . For
additional programming information, see Section 4.3.4 .
Figure 85. Error, Reset, and Special Event Interrupt Condition Status Register
(ERR_RST_EVNT_ICSR) - Address Offset 0270h
31 17 16
Reserved ICS16
R-0 R-0
15 12 11 10 9 8 7 3 2 1 0
Reserved ICS11 ICS10 ICS9 ICS8 Reserved ICS2 ICS1 ICS0
R-0 R-0 R-0 R-0 R-0 R-0 R-0 R-0 R-0
LEGEND: R = Read only; W = Write only; - n = Value after reset
Table 75. Error, Reset, and Special Event Interrupt Condition Status Register
(ERR_RST_EVNT_ICSR) Field Descriptions
Bit Field Value Description
31–17 Reserved 0 These reserved bits return 0s when read.
16 ICS16 0 Device reset interrupt not received from any port
1 Device reset interrupt received from any port
15–12 Reserved 0 These reserved bits return 0s when read.
11 ICS11 0 Error not detected on port 3
1 Error detected on port 3
10 ICS10 0 Error not detected on port 2
1 Error detected on port 2
9 ICS9 0 Error not detected on port 1
1 Error detected on port 1
8 ICS8 0 Error not detected on port 0
1 Error detected on port 0
7–3 Reserved 0 These reserved bits return 0s when read.
2 ICS2 0 Logical layer error management event capture not detected
1 Logical layer error management event capture detected
1 ICS1 0 Port-write-in request not received on any port
1 Port-write-in request received on any port
0 ICS0 0 Multi-cast event control symbol interrupt not received on any port
1 Multi-cast event control symbol interrupt received on any port
Serial RapidIO (SRIO)142 SPRUE13A – September 2006
Submit Documentation Feedback