Serial RapidIO (SRIO) User's Guide

www.ti.com
5.5 Peripheral Global Enable Register (GBL_EN)
SRIO Registers
GBL_EN is implemented with a single enable bit for the entire SRIO peripheral. This bit is logically ORed
with the reset input to the module and is fanned out to all logical blocks within the peripheral. GBL_EN is
shown in Figure 66 and described in Table 44 . For additional programming information, see
Section 2.3.10 .
Figure 66. Peripheral Global Enable Register (GBL_EN) (Address Offset 0030h)
31 1 0
Reserved EN
R-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; - n = Value after reset
Table 44. Peripheral Global Enable Register (GBL_EN) Field Descriptions
Bit Field Value Description
31–1 Reserved 00000000h These read-only bits return 0s when read.
0 EN Global enable. This bit controls reset to all clock domains within the peripheral.
0 The peripheral is to be disabled (held in reset with clocks disabled).
1 The peripheral is to be enabled.
Serial RapidIO (SRIO)116 SPRUE13A – September 2006
Submit Documentation Feedback