Datasheet

TMS320F28335, TMS320F28334, TMS320F28332
TMS320F28235, TMS320F28234, TMS320F28232
www.ti.com SPRS439M –JUNE 2007–REVISED AUGUST 2012
Table 6-16. STANDBY Mode Timing Requirements
TEST CONDITIONS MIN NOM MAX UNIT
Without input qualification 3t
c(OSCCLK)
Pulse duration, external
t
w(WAKE-INT)
cycles
wake-up signal
With input qualification
(1)
(2 + QUALSTDBY) * t
c(OSCCLK)
(1) QUALSTDBY is a 6-bit field in the LPMCR0 register.
Table 6-17. STANDBY Mode Switching Characteristics
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
Delay time, IDLE instruction
t
d(IDLE-XCOL)
32t
c(SCO)
45t
c(SCO)
cycles
executed to XCLKOUT low
Delay time, external wake
t
d(WAKE-STBY)
signal to program execution cycles
resume
(1)
Without input qualifier 100t
c(SCO)
• Wake up from flash
cycles
– Flash module in active
With input qualifier 100t
c(SCO)
+ t
w(WAKE-INT)
state
Without input qualifier 1125t
c(SCO)
• Wake up from flash
cycles
– Flash module in sleep
With input qualifier 1125t
c(SCO)
+ t
w(WAKE-INT)
state
Without input qualifier 100t
c(SCO)
cycles
• Wake up from SARAM
With input qualifier 100t
c(SCO)
+ t
w(WAKE-INT)
(1) This is the time taken to begin execution of the instruction that immediately follows the IDLE instruction. execution of an ISR (triggered
by the wake up signal) involves additional latency.
Copyright © 2007–2012, Texas Instruments Incorporated Electrical Specifications 135
Submit Documentation Feedback
Product Folder Link(s): TMS320F28335 TMS320F28334 TMS320F28332 TMS320F28235 TMS320F28234
TMS320F28232