Datasheet

PWM
(B)
TZ
(A)
SYSCLK
t
w(TZ)
t
d(TZ-PWM)HZ
TMS320F28030, TMS320F28031, TMS320F28032
TMS320F28033, TMS320F28034, TMS320F28035
www.ti.com SPRS584J –APRIL 2009–REVISED OCTOBER 2013
6.11 Enhanced Control Peripherals
6.11.1 Enhanced Pulse Width Modulator (ePWM) Timing
PWM refers to PWM outputs on ePWM1–7. Table 6-19 shows the PWM timing requirements and Table 6-
20, switching characteristics.
Table 6-19. ePWM Timing Requirements
(1)
TEST CONDITIONS MIN MAX UNIT
t
w(SYCIN)
Sync input pulse width Asynchronous 2t
c(SCO)
cycles
Synchronous 2t
c(SCO)
cycles
With input qualifier 1t
c(SCO)
+ t
w(IQSW)
cycles
(1) For an explanation of the input qualifier parameters, see Table 6-12.
Table 6-20. ePWM Switching Characteristics
over recommended operating conditions (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN MAX UNIT
t
w(PWM)
Pulse duration, PWMx output high/low 33.33 ns
t
w(SYNCOUT)
Sync output pulse width 8t
c(SCO)
cycles
t
d(PWM)tza
Delay time, trip input active to PWM forced high no pin load 25 ns
Delay time, trip input active to PWM forced low
t
d(TZ-PWM)HZ
Delay time, trip input active to PWM Hi-Z 20 ns
6.11.2 Trip-Zone Input Timing
Table 6-21. Trip-Zone Input Timing Requirements
(1)
MIN MAX UNIT
t
w(TZ)
Pulse duration, TZx input low Asynchronous 2t
c(TBCLK)
cycles
Synchronous 2t
c(TBCLK)
cycles
With input qualifier 2t
c(TBCLK)
+ t
w(IQSW)
cycles
(1) For an explanation of the input qualifier parameters, see Table 6-12.
A. TZ - TZ1, TZ2, TZ3 , TZ4, TZ5, TZ6
B. PWM refers to all the PWM pins in the device. The state of the PWM pins after TZ is taken high depends on the PWM
recovery software.
Figure 6-18. PWM Hi-Z Characteristics
Copyright © 2009–2013, Texas Instruments Incorporated Electrical Specifications 125
Submit Documentation Feedback
Product Folder Links: TMS320F28030 TMS320F28031 TMS320F28032 TMS320F28033 TMS320F28034
TMS320F28035