Network Card User Manual

Ethernet Media Access Controller (EMAC) Registers www.ti.com
5.22 Receive Unicast Enable Set Register (RXUNICASTSET)
The receive unicast enable set register (RXUNICASTSET) is shown in Figure 61 and described in
Table 59.
Figure 61. Receive Unicast Enable Set Register (RXUNICASTSET)
31 16
Reserved
R-0
15 8
Reserved
R-0
7 6 5 4 3 2 1 0
RXCH7EN RXCH6EN RXCH5EN RXCH4EN RXCH3EN RXCH2EN RXCH1EN RXCH0EN
R/W1S-0 R/W1S-0 R/W1S-0 R/W1S-0 R/W1S-0 R/W1S-0 R/W1S-0 R/W1S-0
LEGEND: R = Read only; R/W = Read/Write; W1S = Write 1 to set, write of 0 has no effect; -n = value after reset
Table 59. Receive Unicast Enable Set Register (RXUNICASTSET) Field Descriptions
Bit Field Value Description
31-8 Reserved 0 Reserved
7 RXCH7EN 0-1 Receive channel 7 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
6 RXCH6EN 0-1 Receive channel 6 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
5 RXCH5EN 0-1 Receive channel 5 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
4 RXCH4EN 0-1 Receive channel 4 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
3 RXCH3EN 0-1 Receive channel 3 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
2 RXCH2EN 0-1 Receive channel 2 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
1 RXCH1EN 0-1 Receive channel 1 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
0 RXCH0EN 0-1 Receive channel 0 unicast enable set bit. Write 1 to set the enable, a write of 0 has no effect.
May be read.
104
Ethernet Media Access Controller (EMAC)/Management Data Input/Output SPRUFI5B–March 2009–Revised December 2010
(MDIO)
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated