Digital Media System-on-Chip (DMSoC) Product Preview
www.ti.com
PRODUCT PREVIEW
6 Revision History
TMS320DM355
Digital Media System-on-Chip (DMSoC)
SPRS463A – SEPTEMBER 2007 – REVISED SEPTEMBER 2007
This data sheet revision history highlights the technical changes made to the SPRS463 device-specific
data sheet to make it an SPRS463A revision.
Scope: Updated DM355 Pin Descriptions table, etc.
ADDS/CHANGES/DELETES
Section 1.1 , Features:
• Video Processing Subsystem feature:
– 14-Bit Parallel AFE (Analog Front End) Interface: Changed speed from 75 MHz to 67.5 MHz
Table 2-1 , Characteristics of the Processor:
• Corrected the Product Status
Updated Table 2-3 , DM355 ARM Configuration Bus Access to Peripherals
Updated Figure 2-1 , Pin Map [Quadrant A]
Updated Figure 2-2 , Pin Map [Quadrant B]
Updated Figure 2-3 , Pin Map [Quadrant C]
Updated Figure 2-4 , Pin Map [Quadrant D]
Table 2-7 , Digital Video Terminal Functions:
• Changed Terminal No. of YOUT7-R7 from "C2" to "C3"
Table 2-9 , Asynchronous EMIF/NAND/OneNAND Terminal Functions:
• Changed Terminal No. of EM_BA0/GIO054/EM_A14 from "T19" to "N19"
• H16: Changed Terminal Name from EM_ AVD/GIO032 to EM_ADV/GIO032
Table 2-10 , DDR Terminal Functions:
• R11: Changed Terminal Name from DDR_VSSDLL to V
SSA_DLL
• R10: Changed Terminal Name from DDR_VDDDLL to V
DDA33_DDRDLL
Updated Table 2-11 , GPIO Terminal Functions
Section 2.4.7 , Universal Serial Bus (USB) Interface:
• Deleted NOTE about OTG supplies not being supported
Updated Table 2-13 , USB Terminal Functions
Table 2-17 , SPI Terminal Functions:
• Changed Terminal No. of GIO007/SPI0_SDENA[1] from "B12" to "C17"
Table 2-21 , System/Boot Terminal Functions:
• Updated all Terminal Names — changed "GOP" to "GIO"
Updated Table 2-23 , DM355 Pin Descriptions
Section 3.1.1 , Components of the ARM Subsystem:
• Updated the "Video Processing Front End (VPFE)" sub-list
Updated Table 3-7 , PLL2 Supported Clocking Configurations for DM355-270 (24 MHz reference)
Table 3-9 :
• Changed title from "PLL2 Supported Clocking Configurations for DM355L (36 MHz reference)" to "PLL2 Supported Clocking
Configurations for DM355-270 (36 MHz reference)"
• Updated table
Section 3.12.1 , Boot Modes Overview:
• "If BTSEL[1:0] = 01" bulleted item: Changed "Asynchronous EMIF (AEMIF or NOR Flash) boot." to "Asynchronous EMIF (AEMIF)
boot."
Section 4.2 , Recommended Operating Conditions:
• Changed V
DD_PLL1
to V
DDA_PLL1
• Changed V
DD_PLL2
to V
DDA_PLL2
• Added V
DDA33_DDRDLL
(Supply voltage, DDR DLL Analog)
• Removed V
DDA18
(Supply voltage, Analog)
• Changed V
SSA_USB
to V
SS_USB
• Removed V
SSA
(Supply ground, Analog)
• Updated descriptions of V
SS_MX1
and V
SS_MX2
Submit Documentation Feedback Revision History 151