Interpolated Control (VIC) Port Reference Guide

Video Display Registers
4-89Video Display PortSPRU629
4.12.26 Video Display Field Bit Register (VDFBIT)
The video display field bit register (VDFBIT) controls the F bit value in the EAV
and SAV timing control codes. The VDFBIT is shown in Figure 4–65 and
described in Table 4–31.
The FBITCLR and FBITSET bits control the F bit value in the EAV and SAV
timing control codes. The F bit is cleared to 0 (indicating field 1 display) in the
EAV code at the beginning of the line whenever the frame line counter (FLCOUNT)
is equal to FBITCLR. It remains a 0 for all subsequent EAV/SAV codes until
the EAV at the beginning of the line when FLCOUNT = FBITSET where it
changes to 1 (indicating field 2 display). The F bit operation is completely inde-
pendent of the FLD control signal.
For interlaced operation, FBITCLR and FBITSET are typically programmed
such that the F bit changes coincidently with or some time after the V bit transi-
tions from 1 to 0 (as determined by VBITCLR1 and VBITCLR2 in VDVBITn).
For progressive scan operation no field 2 output occurs, so FBITSET should
be programmed to a value greater than FRMHEIGHT so that the condition
FLCOUNT = FBITSET never occurs and the F bit is always 0.
Figure 4–65. Video Display Field Bit Register (VDFBIT)
31 28 27 16
Reserved
FBITSET
R-0 R/W-0
15 12 11 0
Reserved
FBITCLR
R-0 R/W-0
Legend: R = Read only; R/W = Read/Write; -n = value after reset
Table 4–31. Video Display Field Bit Register (VDFBIT) Field Descriptions
Description
Bit field
†
symval
†
Value
BT.656 and Y/C Mode
Raw Data Mode
31–28 Reserved – 0 Reserved. The reserved bit location is always read as 0. A
value written to this field has no effect.
27–16 FBITSET OF(value) 0–FFFh Specifies the first line with an EAV of
F = 1 indicating field 2 display.
Not used.
15–12 Reserved – 0 Reserved. The reserved bit location is always read as 0. A
value written to this field has no effect.
11–0 FBITCLR OF(value) 0–FFFh Specifies the first line with an EAV of
F = 0 indicating field 1 display.
Not used.
†
For CSL implementation, use the notation VP_VDFBIT_field_symval