Datasheet

"#$%
SLLS672A − OCTOBER 2005 − REVISED JANUARY 2006
www.ti.com
2
ABSOLUTE MAXIMUM RATINGS
(1)
Power Supply, V+ 7.0V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Input Voltage
(2)
−0.5V to 7.0V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Input Current 10mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating Temperature Range −55°C to +127°C. . . . . . . . . . . . . . .
Storage Temperature Range −60°C to +130°C. . . . . . . . . . . . . . . . .
Junction Temperature (T
J
max) +150°C. . . . . . . . . . . . . . . . . . . . . .
ESD Rating
(3)
:
Human Body Model (HBM) 2000V. . . . . . . . . . . . . . . . . . . . . . .
Charged-Device Model (CDM) 500V. . . . . . . . . . . . . . . . . . . . . .
Machine Model (MM) 200V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
(1)
Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods
may degrade device reliability. These are stress ratings only, and
functional operation of the device at these or any other conditions
beyond those specified is not supported.
(2)
Input voltage rating applies to all TMP106 input voltages.
(3)
ESD testing has been tested to TI specifications JEDEC
J−Std 020.
This integrated circuit can be damaged by ESD. Texas
Instruments recommends that all integrated circuits be
handled with appropriate precautions. Failure to observe
proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to
complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could
cause the device not to meet its published specifications.
ORDERING INFORMATION
(1)
PACKAGE PART NUMBER SYMBOL
Wafer chip-scale package (YZC) TMP106YZC F7
(1)
For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI website
at www.ti.com.
PIN ASSIGNMENTS
A1
B1
C1
A2
B2
C2
SDA
SCL
V+
GND
ALERT
A0
WCSP−6 PACKAGE
(TOP VIEW)
Note: Pin 1 is determined by orienting the package marking as indicated in the diagram.
(Bump Side Down)