Datasheet

ManualsBrandsTEXAS INSTRUMENTS ManualsDev KitsPCB design board

[M3]-JP1

Aux-DC-

Power Input

[M4]-JP1

USB Emulation

& SCI (UART)

Communication

[M3]-SW1

Aux-DC-

Power Switch

[M4]-J2

External JTAG

Connector

[Main]-J2

400V-to-15V to Aux-

DC-Power Jumper

[Main]-J4

5V Enable

Jumper

[Main]-J4

3V3 Enable

Jumper

[M1]-GND-S

Secondary Ground

[Main]-BS1

Input Voltage

[Main]-BS2

Primary Ground

[Main]-H1

DIM100

controlCARD Socket

[Main]-J1

Vin to 400V-to-

15V Jumper

[M1]-GND-P

Primary Ground

[Main]-J3

12-15V Enable

Jum

per

[Main]-J6

JTAG Enable

[Main]-BS4

Secondary

Ground

[Main]-BS3

Output Voltage

[M4]-J5

On-Board Emulation

Disable Jum

per

[M4]-J4

FTDI UART

Enable

[Main]-J7

V-SR2 /

I-SR2 Mux

[Main]-J8

V-SR1 /

I-SR1 Mux

Hardware Resource Mapping

www.ti.com

Table 3. Description of Jumpers, Connectors, and Switches (continued)

[Main]-J5 3V3 Enable Jumper. Enables the 3V3 auxiliary power rail.

[Main]-J6 JTAG enable jumper. Enables JTAG connection to the microcontroller. This jumper needs to be unpopulated

when booting from FLASH, SCI, or another medium.

[Main]-J7 Mux selection between V-SR2 (pins 2-3) and I-SR2 (pins 1-2).

[Main]-J8 Mux selection between V-SR1 (pins 2-3) and I-SR1 (pins 1-2).

[M1]-GND-P Primary Ground. Provides a connection to the primary ground.

[M1]-GND-S Secondary Ground. Provides a connection to the secondary ground.

[M3]-JP1 Aux-DC-Power Input. This connector is designed to connect up with the 12 V power supply included with this

kit and supplies power to the auxiliary power rail powering the C2000 MCU and support chips.

[M3]-SW1 Aux-DC-Power Switch. Turns power to the Aux-DC-Power macro on and off.

[M4]-J2 External JTAG connector. This connector gives access to the JTAG emulation pins. If external emulation is

desired, place a jumper across [M4]-J5 and connect the emulator to the board. However, a USB connector will

still need to be connected to [M2]-JP1 to power the emulation logic.

[M4]-J4 FTDI UART enable jumper. Populate this jumper when using the FTDI chip as a UART (when using a GUI to

interact with the MCU).

[M4]-J5 On-board emulation disable jumper: Place a jumper here to disable the on-board emulator and give access to

the external JTAG interface.

[M4]-JP1 USB connector for on-board JTAG emulation and SCI (UART) communication.

Figure 6. TMDSHVRESLLCKIT Jumpers, Connectors, and Switches Locations

High-Voltage Half-Bridge LLC Resonant DC/DC Converter With Synchronous SPRABS1–February 2013

Rectification Hardware Kit

Submit Documentation Feedback