Datasheet

XDS560 Features
1-2
1.1 XDS560 Features
This technical reference describes the fundamentals of XDS560 PCI Emulator
and Pod and how to interface it to a target system.
The XDS560 emulator target interface and connector are designed to be back-
wards compatible with the XDS510 emulator using either the 3/5V or 1.8/5V
pod.
Features of the XDS560:
- PCI-bus based emulator board
- Support for HS-RTDX enabled devices
- Wide dynamic operating voltage: 0.5 to 5.0 volts
- Programmable TCK: 500KHz to 35MHz
- Overall cable/pod length of 6ft (1.5m) with the pod dimensions of 1.5” x 3”
x 0.4” (38mm x 75mm x 10mm)
- All output target signals are Hi-Zt when connected or powered-on
- All pod signals are ESD protected
- Hardware detection of power losses and cable disconnects
Texas Instrument’s emulation logic and emulation tools are specifically de-
signed to work together complimenting TI’s Digital Signal Processors.
A fundamental understanding of emulation will accelerate your set up, devel-
opment and software debug. This knowledge will also aid in troubleshooting
potential problems in your debugging setup