Datasheet

1 Hardware Setup
2 Software Setup
Hardware Setup www.ti.com
This Kit contains all the hardware needed to get started except a JTAG emulator (suggested emulators
are listed at the end of this document). Please follow the steps below to setup the hardware:
• Unpack the DIM style controlCARD
• Spread open the winged retaining clips on connector J1
• Sit the DIM card loosely in the connector slot. Make sure to align the 2 keyed notches and position the
card bottom corners inside the retaining clips (see Figure 1 )
• Push vertically down using even pressure from both ends of the card until the clips snap and lock.
(note: to remove or eject the card simply spread open the retaining clips with thumbs)
• Connect the 5-V power supply to power jack JP1, ensure switch 1 (SW1) is in off position
• Place jumper a J12 for 3.3-V emulator reference voltage
• Connect the JTAG emulator cable to connector J2
• Once you have downloaded the TI Software or are ready to run your own project, turn on the board
power.
• For full details (schematics, pin-out table, etc.) of the Hardware please refer to the Hardware
Developer’s package, DockingStnHWdevPkg
Figure 1. Retaining Clips
Note: The C2834x requires an update to Code Composer Studio™. Please visit
www.ti.com/f28xkits to download the update.
2 TMS320C2000™ DIM168 Experimenter’s Kit Overview SPRUFT7 – March 2009
Submit Documentation Feedback