Datasheet

www.ti.com
ABSOLUTE MAXIMUM RATINGS
DISSIPATION RATINGS
RECOMMENDED OPERATING CONDITIONS
TMDS341A
SLLS702B MAY 2006 REVISED MARCH 2007
over operating free-air temperature range (unless otherwise noted)
(1)
UNIT
Supply voltage range, V
CC
(2)
–0.5 V to 4 V
Anm
(3)
, Bnm 2.5 V to 4 V
Voltage range Ym, Zm, VSADJ, PRE, Sn, OE, HPDn –0.5V to 4 V
SCLn, SCL_SINK, SDAn, SDA_SINK, HPD_SINK –0.5 V to 6 V
Anm, Bnm 5 kV
Human body model
(4)
All pins 4 kV
Electrostatic
discharge
Charged-device model
(5)
(all pins) 1000 V
Machine model
(6)
(all pins) 250 V
See Dissipation Rating
Continuous power dissipation
Table
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values, except differential I/O bus voltages, are with respect to network ground terminal.
(3) n = 1, 2, 3; m = 1, 2, 3, 4
(4) Tested in accordance with JEDEC Standard 22, Test Method A114-B
(5) Tested in accordance with JEDEC Standard 22, Test Method C101-A
(6) Tested in accordance with JEDEC Standard 22, Test Method A115-A
DERATING FACTOR
(1)
T
A
= 70 ° C
PACKAGE T
A
25 ° C
ABOVE T
A
= 25 ° C POWER RATING
80-TQFP 1342 mW 13.42 mW/ ° C 738 mW
(1) This is the inverse of the junction-to-ambient thermal resistance when board-mounted and with no air flow.
MIN NOM MAX UNIT
V
CC
Supply voltage 3 3.3 3.6 V
T
A
Operating free-air temperature 0 70 ° C
TMDS DIFFERENTIAL PINS (A/B)
V
ID
Receiver peak-to-peak differential input voltage 150 1560 mVp-p
V
IC
Input common mode voltage V
CC
–0.4 V
CC
+0.01 V
R
VSADJ
Resistor for TMDS compliant voltage swing range 4.6 4.64 4.68 k
AV
CC
TMDS output termination voltage, see Figure 1 3 3.3 3.6 V
R
T
Termination resistance, see Figure 1 45 50 55
Signaling rate 0 2.25 Gbps
CONTROL PINS (PRE; S, OE)
V
IH
LVTTL High-level input voltage 2 V
CC
V
V
IL
LVTTL Low-level input voltage GND 0.8 V
DDC I/O PINS (SCL, SCL_SINK, SDA, SDA_SINK)
V
I(DDC)
Input voltage GND 5.5 V
STATUS PINS (HPD_SINK)
V
IH
LVTTL High-level input voltage 2 5.3 V
V
IL
LVTTL Low-level input voltage GND 0.8 V
7
Submit Documentation Feedback