Datasheet

www.ti.com
Bill of Materials
6 Bill of Materials
Table 2. Bill of Materials
PWR019- PWR019- PWR019-
001 002 003
COUNT COUNT COUNT RefDes Value Description Size Part Number MFR
1 1 1 C1 0.1uF Capacitor, Ceramic, 10V, X7R, 20% 0603 STD STD
4 4 4 J1, J2, J3, PEC02SAAN Header, Male 2-pin, 100mil spacing 0.100 inch x 2 PEC02SAAN Sullins
J4
0 0 1 JP1 PEC02SAAN Header, Male 2-pin, 100mil spacing 0.100 inch x 2 PEC02SAAN Sullins
0 0 1 R1 49.9k Resistor, Chip, 1/16W, 1% 0603 STD STD
1 0 0 U1 TLV809KDBZ IC, Voltage Supervisors with Active-Low, Push-Pull SOT23-3 TLV809K33DBZ TI
RESET
0 1 0 U1 TLV810SDBZ IC, Voltage Supervisors with Active-High, Push-Pull SOT23-3 TLV810SDBZ TI
RESET
0 0 1 U1 TLV803SDBZ IC, Voltage Supervisors with Active-Low, Open-Drain SOT23-3 TLV803SDBZ TI
RESET
0 0 1 Shunt, 100-mil, Black 0.1 929950-00 3M
1 1 1 Label 1.25 x 0.25 inch THT-13-457-10 Brady
1 1 1 PWR019 1.645 x 1.300 x 0 .062 inch 2 layer 2oz. PCB 1.645 inch x 1.300 inch PWR019 Any
Notes 1. These assemblies are ESD sensitive, ESD precautions shall be observed.
2. These assemblies must be clean and free from flux and all contaminants. Use of no clean flux is not acceptable.
3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.
4. Ref designators marked with an asterisk ('**') cannot be substituted. All other components can be substituted with equivalent MFG's components.
5. Install label after final wash. Text shall be 8 pt font. Text shall be per Table 3.
Table 3. Assembly Number and Corresponding Label Text
Assembly Number Text
PWR019-001 TLV809KEVM-019
PWR019-002 TLV810SEVM-019
PWR019-003 TLV803SEVM-019
7
SLVU461 May 2011 TLV8xxxEVM-019 Evaluation Modules
Submit Documentation Feedback
Copyright © 2011, Texas Instruments Incorporated