Datasheet

www.ti.com Bill of Material
8 Bill of Material
Table 2. TLV713xxPEVM-171 Bill of Material
-001 -002 -003 RefDes Value Description Size Part Number MFR
2 2 2 C1-2 1 µF Capacitor, ceramic chip, 10 V, ±10%, X5R 0402 STD STD
4 4 4 J1-4 PEC02SAAN Header, male 2-pin, 100-mil spacing, 0.100 inch × 2 PEC02SAAN Sullins
1 1 1 JP1 PEC03SAAN Header, male 3-pin, 100-mil spacing, 0.100 inch × 3 PEC03SAAN Sullins
1 1 1 R1 10 kΩ Resistor, chip, 1/16W, 1% 0402 Std Std
IC, 150 mA, low IQ, ultra small LDO voltage
1 0 0 U1 TLV71312PDQN QFN TLV71312PDQN TI
reg.
IC, 150 mA, low IQ, ultra small LDO voltage
0 1 0 U1 TLV71318PDQN QFN TLV71318PDQN TI
reg.
IC, 150 mA, low IQ, ultra small LDO voltage
0 0 1 U1 TLV71333PDQN QFN TLV71333PDQN TI
reg.
1 1 1 -- PCB, 1.7 in × 1 in × 0.062 in PWR171A Any
1 1 1 JP1 Shunt, black 100-mil 929950-00 3M
1 1 1 Label 1.25 × 0.25 inch THT-13-457-10 Brady
Notes: 1. These assemblies are ESD sensitive, observe ESD precautions.
2. These assemblies must be clean and free from flux and all contaminants. Use of no-clean flux is not acceptable.
3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.
Ref designators marked with an asterisk ('**') cannot be substituted. All other components can be substituted with equivalent MFG's
4.
components.
5. Install label after wash. Text shall be 8 pt font. Text shall be per Table 1 below
Table 1
Assembly No. Text
PWR171-001 TLV71312PEVM-171
PWR171-002 TLV71333PEVM-171
PWR171-003 TLV71333PEVM-171
7
SLVU771–September 2012 TLV713xxPEVM-171 Evaluation Module
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated