Datasheet
SLAS231B − JUNE 1999 − REVISED APRIL 2004
11
WWW.TI.COM
APPLICATION INFORMATION
general function
The TLV5623 is an 8-bit single supply DAC based on a resistor string architecture. The device consists of a serial
interface, speed and power-down control logic, a reference input buffer, a resistor string, and a rail-to-rail output
buffer.
The output voltage (full scale determined by external reference) is given by:
2REF
CODE
2
n
[V]
where REF is the reference voltage and CODE is the digital input value within the range of 0
10
to 2
n−1
, where
n = 8 (bits). The 16-bit data word, consisting of control bits and the new DAC value, is illustrated in the data format
section. A power-on reset initially resets the internal latches to a defined state (all bits zero).
serial interface
The device has to be enabled with CS set to low. A falling edge of FS starts shifting the data bit-per-bit (starting
with the MSB) to the internal register on the falling edges of SCLK. After 16 bits have been transferred or FS
rises, the content of the shift register is moved to the DAC latch, which updates the voltage output to the new
level.
The serial interface of the TLV5623 can be used in two basic modes:
D Four wire (with chip select)
D Three wire (without chip select)
Using chip select (four-wire mode), it is possible to have more than one device connected to the serial port of
the data source (DSP or microcontroller). The interface is compatible with the TMS320 family. Figure 15 shows
an example with two TLV5623s connected directly to a TMS320 DSP.
TMS320
DSP
XF0
XF1
FSX
DX
CLKX
TLV5623
CS
FS DIN SCLK
TLV5623
CS
FS DIN SCLK
Figure 15. TMS320 Interface