Datasheet

TLV320DAC3101
www.ti.com SLAS666A –JANUARY 2010–REVISED MAY 2012
Page 0 / Register 60 (0x3C): DAC Processing Block Selection
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7–D5 R/W 000 Reserved. Write only default value.
D4–D0 R/W 00 0001 0 0000: Reserved. Do not use.
0 0001: DAC Signal Processing Block PRB_P1
0 0010: DAC Signal Processing Block PRB_P2
0 0011: DAC Signal Processing Block PRB_P3
0 0100: DAC Signal Processing Block PRB_P4
...
1 1000: DAC Signal Processing Block PRB_P24
1 1001: DAC Signal Processing Block PRB_P25
1 1010–1 1111: Reserved. Do not use.
Page 0 / Register 61–62: Reserved
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7–D0 R XXXX XXXX Reserved. Do not write.
Page 0 / Register 63 (0x3F): DAC Data-Path Setup
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7 R/W 0 0: Left-channel DAC is powered down.
1: Left-channel DAC is powered up.
D6 R/W 0 0: Right-channel DAC is powered down.
1: Right-channel DAC is powered up.
D5–D4 R/W 01 00: Left-channel DAC data path = off
01: Left-channel DAC data path = left data
10: Left-channel DAC data path = right data
11: Left-channel DAC data path = left-channel and right-channel data ((L + R)/2)
D3–D2 R/W 01 00: Right-channel DAC data path = off
01: Right-channel DAC data path = right data
10: Right-channel DAC data path = left data
11: Right-channel DAC data path = left-channel and right-channel data ((L + R)/2)
D1–D0 R/W 00 00: DAC channel volume control soft-stepping is enabled for one step per sample period.
01: DAC channel volume control soft-stepping is enabled for one step per two sample periods.
10: DAC channel volume control soft-stepping is disabled.
11: Reserved. Do not write this sequence to these bits.
Page 0 / Register 64 (0x40): DAC VOLUME CONTROL
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7–D4 R/W 0000 Reserved. Write only zeros to these bits.
D3 R/W 1 0: Left-channel DAC not muted
1: Left-channel DAC muted
D2 R/W 1 0: Right-channel DAC not muted
1: Right-channel DAC muted
D1–D0 R/W 00
(1)
00: Left and right channels have independent volume control.
01: Left-channel volume control Is the programmed value of right-channel volume control.
10: Right-channel volume control is the programmed value of left-channel volume control.
11: Same as 00
(1) When DRC is enabled, left and right channel volume controls are always independent. Program bits D1–D0 to 00.
Copyright © 2010–2012, Texas Instruments Incorporated REGISTER MAP 73
Submit Documentation Feedback
Product Folder Link(s): TLV320DAC3101