Datasheet

÷ M

GPIO1 (CLKOUT)

CDIV_CLKIN

MCLK BCLK DIN

PLL_CLK

DAC_CLK

DAC_MOD_CLK

M = 1, 2, ..., 127, 128

B0363-01

PLL_CLKIN R J.D

PLL_CLK

´ ´

TLV320DAC3101

www.ti.com

SLAS666A –JANUARY 2010–REVISED MAY 2012

Figure 5-22. General-Purpose Clock Output Options

Table 5-27. Maximum TLV320DAC3101 Clock Frequencies

Clock DVDD ≥ 1.65 V

CODEC_CLKIN ≤ 110 MHz

DAC_CLK (DAC processing clock) ≤ 49.152 MHz

DAC_MOD_CLK 6.758 MHz

DAC_f

0.192 MHz

BDIV_CLKIN 55 MHz

CDIV_CLKIN 100 MHz when M is odd

110 MHz when M is even

5.6.1 PLL

For lower power consumption, it is best to derive the internal audio processing clocks using the simple

dividers. When the input MCLK or other source clock is not an integer multiple of the audio processing

clocks then it is necessary to use the on-board PLL. The TLV320DAC3101 fractional PLL can be used to

generate an internal master clock used to produce the processing clocks needed by the DAC. The

programmability of this PLL allows operation from a wide variety of clocks that may be available in the

system.

The PLL input supports clocks varying from 512 kHz to 20 MHz and is register-programmable to enable

generation of the required sampling rates with fine resolution. The PLL can be turned on by writing to

page 0 / register 5, bit D7. When the PLL is enabled, the PLL output clock, PLL_CLK, is given by the

following equation:

(6)

where

R = 1, 2, 3, ..., 16 (page 0 / register 5, default value = 1)

J = 1, 2, 3, …, 63 (page 0 / register 6, default value = 4)

D = 0, 1, 2, …, 9999 (page 0 / register 7 and page 0 / register 8, default value = 0)

P = 1, 2, 3, …, 8 (page 0 / register 5, default value = 1)

Submit Documentation Feedback

Product Folder Link(s): TLV320DAC3101