Datasheet

TLV320AIC3204
SLOS602B –SEPTEMBER 2008–REVISED OCTOBER 2012 www.ti.com
Electrical Characteristics, ADC
At 25°C, AV
DD
, DV
DD
, IOV
DD
= 1.8V, LDOIN = 3.3V, AV
DD
LDO disabled, f
s
(Audio) = 48kHz, C
ref
= 10µF on REF pin, PLL
disabled unless otherwise noted.
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
AUDIO ADC
(1) (2)
Input signal level (0dB) Single-ended, CM = 0.9V 0.5 V
RMS
1kHz sine wave input
Single-ended Configuration
IN1R to Right ADC and IN1L to Left ADC,
R
in
= 20K, f
s
= 48kHz,
Device Setup AOSR = 128, MCLK = 256 * f
s
,
PLL Disabled; AGC = OFF,
Channel Gain = 0dB,
Processing Block = PRB_R1,
Power Tune = PTM_R4
Inputs ac-shorted to ground 80 93
Signal-to-noise ratio, A-
SNR dB
IN2R, IN3R routed to Right ADC and ac-shorted to ground 93
weighted
(1)(2)
IN2L, IN3L routed to Left ADC and ac-shorted to ground
DR Dynamic range A-weighted
(1)(2)
–60dB full-scale, 1-kHz input signal 92 dB
–3 dB full-scale, 1-kHz input signal –85 –70 dB
Total Harmonic Distortion plus
IN2R,IN3R routed to Right ADC –85
THD+N
Noise
IN2L, IN3L routed to Left ADC
–3dB full-scale, 1-kHz input signal
AUDIO ADC
Input signal level (0dB) Single-ended, CM = 0.75V, AV
DD
= 1.5V 0.375 V
RMS
1kHz sine wave input
Single-ended Configuration
IN1R, IN2R, IN3R routed to Right ADC
IN1L, IN2L, IN3L routed to Left ADC
R
in
= 20kΩ, f
s
= 48kHz,
Device Setup
AOSR = 128, MCLK = 256* f
s
,
PLL Disabled, AGC = OFF,
Channel Gain = 0dB,
Processing Block = PRB_R1
Power Tune = PTM_R4
SNR Signal-to-noise ratio, A-weighted Inputs ac-shorted to ground 91 dB
(1)(2)
DR Dynamic range A-weighted
(1)(2)
–60dB full-scale, 1-kHz input signal 90 dB
THD+N Total Harmonic Distortion plus –3dB full-scale, 1-kHz input signal –80 dB
Noise
(1) Ratio of output level with 1kHz full-scale sine wave input, to the output level with the inputs short circuited, measured A-weighted over a
20Hz to 20kHz bandwidth using an audio analyzer.
(2) All performance measured with 20kHz low-pass filter and, where noted, A-weighted filter. Failure to use such a filter may result in higher
THD+N and lower SNR and dynamic range readings than shown in the Electrical Characteristics. The low-pass filter removes out-of-
band noise, which, although not audible, may affect dynamic specification values.
8 Submit Documentation Feedback Copyright © 2008–2012, Texas Instruments Incorporated
Product Folder Links: TLV320AIC3204