Datasheet

LD(n) LD(n+1)
WORD
CLOCK
BIT
CLOCK
DATA
-
1
-
2
-
3
2 1 03 -
1
-
2
-
3
2 1 03 -
1
-
2
N N N N N N N N N
-
3
RD(n)
LEFT CHANNEL RIGHT CHANNEL
LD(n)=n'thsampleofleftchanneldata RD(n)=n'thsampleofrightchanneldata
BCLK
WCLK
DIN/DOUT
n-1 n-2 1 00 n-1 n-2 1 0
LSBMSB
LeftChannel RightChannel
n-3 2 2n-3
LSBMSB
1/fs
TLV320AIC3110
SLAS647B DECEMBER 2009REVISED MAY 2012
www.ti.com
The TLV320AIC3110 further includes programmability (page 0 / register 27, D0) to place the DOUT line in
the high-impedance state during all bit clocks when valid data is not being sent. By combining this
capability with the ability to program at what bit clock in a frame the audio data begins, time-division
multiplexing (TDM) can be accomplished, enabling the use of multiple codecs on a single audio serial data
bus. When the audio serial data bus is powered down while configured in master mode, the pins
associated with the interface are put into a high-impedance output state.
By default, when the word clocks and bit clocks are generated by the TLV320AIC3110, these clocks are
active only when the codecs (ADC, DAC or both) are powered up within the device. This is done to save
power. However, it also supports a feature whereby both the word clocks and bit-clocks can be active
even when the codec in the device is powered down. This is useful when using the TDM mode with
multiple codecs on the same bus, or when word clocks or bit clocks are used in the system as general-
purpose clocks.
5.7.1.1 Right-Justified Mode
The audio interface of the TLV320AIC3110 can be put into right-justified mode by programming page 0 /
register 27, bits D7–D6 = 10. In right-justified mode, the LSB of the left channel is valid on the rising edge
of the bit clock preceding the falling edge of the word clock. Similarly, the LSB of the right channel is valid
on the rising edge of the bit clock preceding the rising edge of the word clock.
Figure 5-40. Timing Diagram for Right-Justified Mode
For right-justified mode, the number of bit clocks per frame should be greater than or equal to twice the
programmed word length of the data.
5.7.1.2 Left-Justified Mode
The audio interface of the TLV320AIC3110 can be put into left-justified mode by programming page 0 /
register 27, bits D7–D6 = 11. In left-justified mode, the MSB of the right channel is valid on the rising edge
of the bit clock following the falling edge of the word clock. Similarly, the MSB of the left channel is valid
on the rising edge of the bit clock following the rising edge of the word clock.
Figure 5-41. Timing Diagram for Left-Justified Mode
72 APPLICATION INFORMATION Copyright © 2009–2012, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: TLV320AIC3110