Datasheet
TLV320AIC3106
SLAS509E – DECEMBER 2006 – REVISED DECEMBER 2008 ........................................................................................................................................
www.ti.com
Page 0 / Register 51: HPLOUT Output Level Control Register
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7 – D4 R/W 0000 HPLOUT Output Level Control
0000: Output level control = 0-dB
0001: Output level control = 1-dB
0010: Output level control = 2-dB
...
1000: Output level control = 8-dB
1001: Output level control = 9-dB
1010 – 1111: Reserved. Do not write these sequences to these register bits.
D3 R/W 0 HPLOUT Mute
0: HPLOUT is muted
1: HPLOUT is not muted
D2 R/W 1 HPLOUT Power Down Drive Control
0: HPLOUT is weakly driven to a common-mode when powered down
1: HPLOUT is high-impedance when powered down
D1 R 1 HPLOUT Volume Control Status
0: All programmed gains to HPLOUT have been applied
1: Not all programmed gains to HPLOUT have been applied yet
D0 R/W 0 HPLOUT Power Control
0: HPLOUT is not fully powered up
1: HPLOUT is fully powered up
Page 0 / Register 52: LINE2L to HPLCOM Volume Control Register
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7 R/W 0 LINE2L Output Routing Control
0: LINE2L is not routed to HPLCOM
1: LINE2L is routed to HPLCOM
D6 – D0 R/W 000 0000 LINE2L to HPLCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 5
Page 0 / Register 53: PGA_L to HPLCOM Volume Control Register
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7 R/W 0 PGA_L Output Routing Control
0: PGA_L is not routed to HPLCOM
1: PGA_L is routed to HPLCOM
D6 – D0 R/W 000 0000 PGA_L to HPLCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 5
Page 0 / Register 54: DAC_L1 to HPLCOM Volume Control Register
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7 R/W 0 DAC_L1 Output Routing Control
0: DAC_L1 is not routed to HPLCOM
1: DAC_L1 is routed to HPLCOM
D6 – D0 R/W 000 0000 DAC_L1 to HPLCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 5
Page 0 / Register 55: LINE2R to HPLCOM Volume Control Register
READ/ RESET
BIT DESCRIPTION
WRITE VALUE
D7 R/W 0 LINE2R Output Routing Control
0: LINE2R is not routed to HPLCOM
1: LINE2R is routed to HPLCOM
D6 – D0 R/W 000 0000 LINE2R to HPLCOM Analog Volume Control
For 7-bit register setting versus analog gain values, see Table 5
68 Submit Documentation Feedback Copyright © 2006 – 2008, Texas Instruments Incorporated
Product Folder Link(s): TLV320AIC3106