Datasheet

TLV320AIC3100
SLAS667A –NOVEMBER 2009–REVISED MAY 2012 www.ti.com
5.5.3 Volume-Control Pin
The volume-control pin is not enabled by default but it can be enabled by writing 1 to page 0 /
register 116, bit D7. The default DAC volume control uses software control of the volume, which occurs if
page 0 / register 116, bit D7 = 0. Soft-stepping the volume level is set up by writing to page 0 / register 63,
bits D1–D0.
When the volume-pin function is used, a 7-bit Vol ADC reads the voltage on the VOL/MICDET pin and
updates the digital volume control. (It overwrites the current value of the volume control.) The new volume
setting which has been applied due to a change of voltage on the volume control pin can be read on
page 0 / register 117, bits D6–D0. The 7-bit Vol ADC clock source can be selected on page 0 /
register 116, bit D6. The update rate can be programmed on page 0 / register 116, bits D2–D0 for this 7-
bit SAR ADC.
The VOL/MICDET pin gain mapping is shown in Table 5-32.
Table 5-32. VOL/MICDET Pin Gain Mapping
VOL/MICDET PIN SAR OUTPUT DIGITAL GAIN APPLIED
0 18 dB
1 17.5 dB
2 17 dB
: :
35 0.5 dB
36 0.0 dB
37 –0.5 dB
: :
89 –26.5 dB
90 –27 dB
91 –28 dB
: :
125 –62 dB
126 –63 dB
127 Mute
54 APPLICATION INFORMATION Copyright © 2009–2012, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): TLV320AIC3100