Datasheet
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2
Frequency Normalized With Respect to f
S
Magnitude dB–
ADC Channel Response for Decimation Filter A
(Red line corresponds to –73 dB)
TLV320ADC3101
SLAS553A – NOVEMBER 2008 – REVISED SEPTEMBER 2009 ......................................................................................................................................
www.ti.com
Decimation Filter A
This filter is intended for use at sampling rates up to 48 kHz. When configuring this filter, the oversampling ratio
of the ADC can either be 128 or 64. For highest performance, the oversampling ratio must be set to 128. Filter A
can also be used for 96 kHz at an AOSR of 64.
Table 10. Specification for ADC Decimation Filter A
Parameter Condition Value (Typical) Unit
AOSR = 128
Filter gain pass band 0 – 0.39 f
S
0.062 dB
Filter gain stop band 0.55 – 64 f
S
– 73 dB
Filter group delay 17/f
S
s
Pass-band ripple, 8 ksps 0 – 0.39 f
S
0.062 dB
Pass-band ripple, 44.18 ksps 0 – 0.39 f
S
0.05 dB
Pass-band ripple, 48 ksps 0 – 0.39 f
S
0.05 dB
AOSR = 64
Filter gain pass band 0 – 0.39 f
S
0.062 dB
Filter gain stop band 0.55 – 32 f
S
– 73 dB
Filter group delay 17/f
S
s
Pass-band ripple, 8 ksps 0 – 0.39 f
S
0.062 dB
Pass-band ripple, 44.18 ksps 0 – 0.39 f
S
0.05 dB
Pass-band ripple, 48 ksps 0 – 0.39 f
S
0.05 dB
Pass-band ripple, 96 ksps 0 – 20 kHz 0.1 dB
Figure 44. ADC Decimation Filter A, Frequency Response
40 Submit Documentation Feedback Copyright © 2008 – 2009, Texas Instruments Incorporated
Product Folder Link(s) :TLV320ADC3101