Datasheet
RD–
RD–
RD+ RD+
49.9 W
49.9 W
Vdd
Vdd
0.1 Fm
0.1 F*m
TD– TD–
TD+
TD+
49.9 W
49.9 W
Vdd
0.1 Fm
1:1
1:1
T1
RJ45
Place resistors and capacitors close to the device.
Common-mode chokes
may be required.
Note: Center tap is connected to Vdd
* Place capacitors close to the
transformer center taps
All values are typical and are 1%±
0.1 F*m
1 Fm
1 Fm
TLK110
www.ti.com
SLLS901D –DECEMBER 2011–REVISED JANUARY 2014
7 Design Guidelines
7.1 TPI Network Circuit
Figure 7-1 shows the recommended circuit for a 10/100Mbs twisted pair interface. Below is a partial
list of recommended transformers. Variations with PCB and component characteristics require that
the application be tested to verify that the circuit meets the requirements of the intended application.
• Pulse H1102
• Pulse HX1198
Figure 7-1. 10/100Mbs Twisted Pair Interface
7.2 Clock In (XI) Requirements
The TLK110 supports an external CMOS-level oscillator source or an internal oscillator with an external
crystal.
7.2.1 Oscillator
If an external clock source is used, XI should be tied to the clock source and XO should be left floating.
The amplitude of the oscillator should be a nominal voltage of 3.3V.
Copyright © 2011–2014, Texas Instruments Incorporated Design Guidelines 39
Submit Documentation Feedback
Product Folder Links: TLK110