Datasheet

LED_LINK
470W
2.2kW
V
CC
AN_O = 1
TLK105
TLK106
SLLSEB8A –AUGUST 2012–REVISED MARCH 2013 www.ti.com
3.8 LED Interface
The TLK10x supports one configurable Light Emitting Diode (LED) pin. The device supports 2 LED
configurations: Link and Activity. Functions are multiplexed into two modes. The LED can be controlled by
configuration pin and internal register bits. Bit 5 of the PHY Control register (PHYCR) selects the LED
mode as described in Table 3-3.
Table 3-3. LED Mode Select
LED_CFG[0]
Mode LED_LINK
(bit 5) or (pin 27)
ON for Good Link
1 1
OFF for No Link
ON for Good Link
2 0
BLINK for Activity
The LED_LINK pin in Mode 1 indicates the link status of the port. The LED is OFF when no link is present.
In Mode 2 it is ON to indicate that the link is good; BLINK indicates that activity is present on either
transmit or receive channel. Bits 10:9 of the LEDCR register (0x18) control the blink rate. The default blink
rate is 5Hz.
See Figure 3-4 for an example of AN_0 connections to external components. In this example, the AN_0
configuration results in Full-Duplex advertised.
Figure 3-4. AN Pin Configuration and LED Loading Example
12 Hardware Configuration Copyright © 2012–2013, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: TLK105 TLK106