Datasheet

TLE2161, TLE2161A, TLE2161B
EXCALIBUR JFET-INPUT HIGH-OUTPUT-DRIVE
µPOWER OPERATIONAL AMPLIFIERS
SLOS049D – NOVEMBER 1989 – REVISED MAY 1996
17
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
TYPICAL CHARACTERISTICS
Table of Graphs
FIGURE
V
IO
Input offset voltage Distribution 4
I
IB
Input bias current
vs Common-mode input voltage
vs Free-air temperature
5
6
I
IO
Input offset current vs Free-air temperature 6
V
ICR
Common-mode input voltage range limits vs Free-air temperature 7
V
OM
Maximum positive peak output voltage vs Output current 8
V
OM
Maximum negative peak output voltage vs Output current 9
V
OM
Maximum peak output voltage vs Supply voltage 10, 11, 12
V
O(PP)
Maximum peak-to-peak output voltage vs Frequency 13, 14, 15
A
VD
Large-signal differential voltage amplification
vs Frequency
vs Free-air temperature
16
17
I
OS
Short-circuit output current vs Elapsed time 18
Large-signal voltage amplification vs Free-air temperature 19
z
o
Output impedance vs Frequency 20
CMRR Common-mode rejection ratio vs Frequency 21
I
CC
Supply current
vs Supply voltage
vs Free-air temperature
22
23
Pulse response
Small signal
Large signal
24, 25
26, 27
Noise voltage (referred to input) 0.1 to 10 Hz 28
V
n
Equivalent input noise voltage vs Frequency 29
THD Total harmonic distortion vs Frequency 30, 31
Gain-bandwidth product
vs Supply voltage
vs Free-air temperature
32
33
φ
m
Phase margin
vs Supply voltage
vs Free-air temperature
34
35
Phase shift vs Frequency 16