Datasheet

TLC2543C, TLC2543I, TLC2543M
12-BIT ANALOG-TO-DIGITAL CONVERTERS
WITH SERIAL CONTROL AND 11 ANALOG INPUTS
SLAS079F – DECEMBER 1993 – REVISED NOVEMBER 2001
11
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
PARAMETER MEASUREMENT INFORMATION
A/D Conversion
Interval
Initialize
MSB LSB
MSB LSB
B7 B6 B5 B4 C7
B15A15 A14 A13 A12 A11 A10 A9 A8 A1 A0
1 2 3 4 5 6 7 8 15 16 1
I/O
CLOCK
DATA
OUT
DATA
INPUT
CS
EOC
Initialize
Hi-Z State
(see Note A)
B3 B2 B1 B0
Access Cycle B Sample Cycle B
Previous Conversion Data
t
(conv)
Shift in New Multiplexer Address,
Simultaneously Shift Out Previous
Conversion Value
NOTE A: To minimize errors caused by noise at CS
, the internal circuitry waits for a setup time after CS↓ before responding to control input signals.
Therefore, no attempt should be made to clock in an address until the minimum CS
setup time has elapsed.
Figure 13. Timing for 16-Clock Transfer Using CS With MSB First
A/D Conversion
Interval
Initialize
MSB LSB
MSB LSB
B7 B6 B5 B4 C7
B15A15 A14 A13 A12 A11 A10 A9 A8 A1 A0
1 2 3 4 5 6 7 8 15 16 1
I/O
CLOCK
DATA
OUT
DATA
INPUT
CS
EOC
Low Level
(see Note A)
B3 B2 B1 B0
Sample Cycle B
Access Cycle B
Previous Conversion Data
t
(conv)
Shift in New Multiplexer Address,
Simultaneously Shift Out Previous
Conversion Value
NOTE A: To minimize errors caused by noise at CS, the internal circuitry waits for a setup time after CS↓ before responding to control input signals.
Therefore, no attempt should be made to clock in an address until the minimum CS
setup time has elapsed.
Figure 14. Timing for 16-Clock Transfer Not Using CS With MSB First