Datasheet

IN
TL783
OUT V
O
R1
R2
ADJ
V
I
C
o
Load Regulation
V
I
TL783
R1
R
line
R
L
R2
V
O
IN OUT
ADJ
TL783
www.ti.com ............................................................................................................................................... SLVS036M – SEPTEMBER 1981 – REVISED APRIL 2008
Care always should be taken to prevent insertion of regulators into a socket with power on. Power should be
turned off before removing or inserting regulators.
Figure 15. Regulator With Protective Diode
The current-set resistor (R1) should be located close to the regulator output terminal, rather than near the load.
This eliminates long line drops from being amplified, through the action of R1 and R2, to degrade load regulation.
To provide remote ground sensing, R2 should be near the load ground.
Figure 16. Regulator With Current-Set Resistor
Copyright © 1981 – 2008, Texas Instruments Incorporated Submit Documentation Feedback 9
Product Folder Link(s): TL783