Datasheet

1111

IER

IIR

RHRTHR

IOW/IOR

INT

B0418-01

Processor

TL16C752B

SLLS405C –DECEMBER 1999–REVISED JUNE 2010

www.ti.com

Table 4. Interrupt Control Functions

PRIORITY INTERRUPT

IIR[5–0] INTERRUPT SOURCE INTERRUPT RESET METHOD

LEVEL TYPE

000001 None None None None

000110 1 Receiver line OE, FE, PE, or BI errors occur in FE, PE, BI: All erroneous characters are read

status characters in the RX FIFO from the RX FIFO.

OE: Read LSR

001100 2 RX timeout Stale data in RX FIFO Read RHR

000100 2 RHR interrupt DRDY (data ready) Read RHR

(FIFO disable)

RX FIFO above trigger level (FIFO

enable)

000010 3 THR interrupt TFE (THR empty) Read IIR OR a write to the THR

(FIFO disable)

TX FIFO passes above trigger level (FIFO

enable)

000000 4 Modem status MSR[3:0] = 0 Read MSR

010000 5 Xoff interruptr Receive Xoff character(s)/special Receive Xon character(s)/Read of IIR¼

character

100000 6 CTS, RTS RTS pin or CTS pin change state from Read IIR

active (low) to inactive (high)

It is important to note that for the framing error, parity error, and break conditions, LSR[7] generates the interrupt.

LSR[7] is set when there is an error anywhere in the RX FIFO and is cleared only when there are no more errors

remaining in the FIFO. LSR[4–2] always represent the error status for the received character at the top of the RX

FIFO. Reading the RX FIFO updates LSR[4–2] to the appropriate status for the new character at the top of the

FIFO. If the RX FIFO is empty, then LSR[4–2] are all zeros.

For the Xoff interrupt, if an Xoff flow character detection caused the interrupt, the interrupt is cleared by an Xon

flow character detection. If a special character detection caused the interrupt, the interrupt is cleared by a read of

the LSR.

Interrupt Mode Operation

In interrupt mode (if any bit of IER[3:0] is 1) the processor is informed of the status of the receiver and transmitter

by an interrupt signal, INT. Therefore, it is not necessary to continuously poll the line stats register (LSR) to see if

any interrupt needs to be serviced. Figure 5 shows interrupt mode operation.

Figure 5. Interrupt Mode Operation

Product Folder Link(s): TL16C752B