User Guide
Table Of Contents
- Setting up the TI‑Nspire™ Navigator™ Teacher Software
- About the Hardware
- Before You Begin
- Charging the Cradles
- Updating the Handheld Operating System
- Connecting the TI‑Nspire™ Navigator™ Access Point
- Confirming Handheld OS Version
- Naming the Class Network
- Adding Wireless Clients to the Network
- Connecting the Handhelds to the Wireless Adapters
- Connecting the Handhelds to Cradles
- Creating and Managing Your Teacher Account
- Logging In to the TI‑Nspire™ Navigator™ System from the Handheld
- Storing the Wireless Adapters and Cradles
- Using TI‑Nspire™ Network Manager
- USA FCC Information Concerning Radio Frequency Interference
- Canadian IC Information
- Mexico - Declaration of Conformity
- European Union and EFTA Regulatory Compliance
- China SRRC CMIIT Identification
- Warning Statements
- Important for Safe AC Adapter Operation
TI-Nspire™ Navigator™ access point TI-Nspire™ CX Navigator™ access point
Note:If the software does not detect a connected access point within one
minute, an error message is displayed. Close the error message, and then
disconnect and reconnect the access point.
2. Click Next.
The software detects the access point type and checks the firmware
version on the access point. If a newer firmware version is available, the
software updates the firmware.
Note: It may take up to 60 seconds for the software to detect the access
point.
Important! Do not stop the update process or disconnect the access point
until the firmware update is complete.
When the update is complete, the software checks the access point for a
configured classroom network.
• If classes exist, the software asks if you want to keep the current setup
or make changes.
• If no classes exist, the Class Network Setup wizard opens.
Note: You can set up a network at any time, or make edits to an existing
network, by using the Network Manager.
Troubleshooting
If the firmware update fails, the OSWarning dialog box opens.
Setting up the TI-Nspire™ Navigator™ Teacher Software 9
DRAFT