User Guide
Table Of Contents
- Setting up the TI‑Nspire™ Navigator™ Teacher Software
- About the Hardware
- Before You Begin
- Charging the Cradles
- Updating the Handheld Operating System
- Connecting the TI‑Nspire™ Navigator™ Access Point
- Confirming Handheld OS Version
- Naming the Class Network
- Adding Wireless Clients to the Network
- Connecting the Handhelds to the Wireless Adapters
- Connecting the Handhelds to Cradles
- Creating and Managing Your Teacher Account
- Logging In to the TI‑Nspire™ Navigator™ System from the Handheld
- Storing the Wireless Adapters and Cradles
- Using TI‑Nspire™ Network Manager
- USA FCC Information Concerning Radio Frequency Interference
- Canadian IC Information
- Mexico - Declaration of Conformity
- European Union and EFTA Regulatory Compliance
- China SRRC CMIIT Identification
- Warning Statements
- Important for Safe AC Adapter Operation
4 Setting up the TI-Nspire™ Navigator™ Teacher Software
Charging the Cradles
The TI-Nspire™ Navigator™ wireless cradles contain rechargeable batteries.
You must charge the batteries overnight before using them in class. When the
cradles are fully charged, they will function all day under continuous use. You
should recharge them each night.
The TI-Nspire™ Navigator™ Cradle Charging Bay can hold from one to five
cradles. After you place the cradles in the charging bay, they are charged
simultaneously until all are fully charged. If the batteries are fully discharged, it
may take up to 12 hours to fully charge the batteries.
Note: You cannot damage the batteries by leaving them in the charging bay
beyond the time needed to fully charge them. Also, it is not necessary to fully
discharge the batteries before recharging them.
Make sure you have enough (3 to 4) power outlets for the equipment you
received. If necessary, obtain a power strip so that you have plenty of grounded
outlets.
1. Insert the small end of the AC9940 power adapter cord into the charging
bay’s power jack.
DRAFT